Special aluminum coil plate for pipeline corrosion prevention and insulation is widely used in desulfurization flue insulation of power plants, gas, chemical plants, oil fields, petrochemicals, nuclear power plants, etc. First of all, because the density of aluminum is only 2.71 g/cm3, while the density of iron reaches 7.8 g/cm3...

Special aluminum coil plate for pipeline corrosion prevention and insulation is widely used in desulfurization flue insulation of power plants, gas, chemical plants, oil fields, petrochemicals, nuclear power plants, etc. First of all, because the density of aluminum is only 2.71 g/cm3, while the density of iron reaches 7.8 g/cm3, the weight of aluminum plate per square meter is less than 1/3 of that of stainless steel, which can well reduce the cost of enterprises and reduce the pressure of supports; Secondly, due to the dense oxide protective film on the surface of aluminum, it is not easy to be corroded, so it has a good anti rust effect. In the external bad environment, rain, sun exposure and heavy snow have little damage to aluminum. It is not like iron sheet, which rust quickly after seeing rain. From the above two points, it can be seen that aluminum can completely replace stainless steel materials to a large extent, and at the same time, the cost is lower. It is the material of construction * *. At present, after nearly 20 years of pipeline insulation experience in China, it has been proved that no one has rusted and rotted with special aluminum coil plate for pipeline corrosion prevention and insulation or antirust aluminum jacketing for insulation; And those that use iron sheet for protection and insulation have been replaced several times.
 
Aluminum coil: 1060, 1170,1100,1145, 8011, 3003, 3004, 5052 etc.
Thickness 0.10mm---14mm
Width 150mm---2000mm
 
The special aluminum coil for pipeline anti-corrosion and insulation is one of our company's characteristic products, with stable chemical composition and excellent performance. According to the user's requirements, the chemical composition of iron (FE), silicon (SI), manganese (MN) and copper (Cu) can also be controlled and fine tuned. The tensile strength is controlled at 95-145mpa, the elongation is ≥ 2%, the thickness is 0.3-1.0mm, and the width is 1.0m or 1.2m. The aluminum coil with different thickness and width can also be customized according to the customer's requirements, and the length meets the user's requirements.